![]() ![]() The mic input has also a significant impact on the compressor performance. By increasing the threshold, the over all audio level will increase. The higher the number of attack or release, the faster it will adjust the level. Release is when the compressor is increasing gain to reach the ratio level. Attack is when the compressor is decreasing gain to reach the ratio level. The compressor has 3 settings: Attack, Release and Threshold. This is an elegant way of overcoming QRMs or bad signal propagation. ![]() ![]() For experts: By reducing the dynamics of the voice signal you can push more ERP (Emitted Radiated Power) out of your HamSphere Transceiver. But should not be used in the long run as it can make your voice hard to listen to. Layman definition: 2ģ Makes your audio stronger and more consistant. (Receiver) : Powerful microphone compressor/processor. : Set Automatic Gain Control to slow or fast. : Toggle between DSB mode (voice) and CW Mode (Morse code) : Turn simulation mode off. Set the VOX delay so that it keeps the PTT hold enough for the pace of speech. Adjust the VOX gain so that it triggers the PTT with your voice only. You can set the VOX levels with the SETTINGS button. Screen before log in 1Ģ Screen after log in BUTTONS EXPLAINED = : Step 1 khz down in VFO mode and memory down in MEM mode : Step 1 khz up in VFO mode and memory up in MEM mode : Set VFO or Memory : Set filter 1 (3.8kHz) or 2 (2.8kHz) : Set VOX operation which means that the PTT can be triggered by your voice. The cluster shows all activity on all servers. If you want to send a global message to all users on all servers you can use the /cluster msg command. Private messages are however relayed between the servers. Standard chat messages are not relayed between the servers as it would clotter the chat list. ![]() To save CPU power and network activity the message system is at very low priority so your chat and private messages can be a little delayed. HamSphere 3.0 has a new messaging system. Therefore you will notice that stations will have different signal levels between the servers. The signal propagation between the servers are based on a spacial Shortwave DX simulation. MULTI SERVER SPHERE = HamSphere 3.0 currently consists of a network of 3 servers. I am very glad if you have any hint from this documents. Kelly Lindman (5B4AIT) but the responsibility for this my own manual is Shu JO3KLS. 1 Personal HamSphere 3.0 Manual = An author is Mr. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |